Shanghai Richeng Electronics Co. Ltd - ISO9001/IATF16949/ISO/TS22163
Choose Language

Wiring duct,Cable Gland,Cable Tie,Terminals,RCCN

Detection and judgment of wiring harness line faults

Detection and judgment of wire harness burnout failure

The burnt wire bundles are all suddenly occurring, and the burning speed is very fast. In the burned circuit, there is generally no safety device. The rule of burning the electric wire bundle is: in the circuit of the power supply system, which point is grounded, where the electric wire bundle is burned, where the burnt and the intact part are at the junction, it can be considered that the electric wire is grounded; if the electric wire bundle is burned out When the wiring to an electrical equipment indicates that the electrical equipment is faulty.

Detection and judgment of short circuit, open circuit and bad contact between lines

The electric wire bundle is subjected to external pressing and impact, causing damage to the electric wire insulation layer in the electric wire bundle, resulting in a short circuit between the electric wires, causing some electrical equipment to lose control and the fuse to be blown.

When judging, the electrical harness connector at both ends of the electrical equipment and the control switch can be disconnected, and the short circuit of the line can be detected by the electric meter or the test light.

In the case of wire breakage failure, in addition to the obvious fracture phenomenon, common faults occur mostly between the wire and the wire terminal. After some wires are broken, the outer insulation layer and the wire terminals are intact, but the inner core wire and the wire terminal of the wire are broken. When judging, the tensile test can be performed on the conductive wire and the wire terminal of the suspected open circuit. During the tensile test, if the wire insulation layer is gradually tapered, it can be confirmed that the wire has been broken.

Poor line contact, faults occur in the connector. When a fault occurs, it may cause the electrical equipment to malfunction. When judging, the power of the electrical device is turned on, and the relevant connector of the electrical device is touched or pulled. When a connector is touched, the operation of the electrical device is normal and abnormal, indicating that the connector is abnormal. failure.

 

 

Related articles

Previous: Inverter maintenance safety precautions
Next: High voltage device safety technology
On-line
contact
message
download
Print
WeChat WeChat
Collection
TOP